Depending on the level of safety required,
the SCHMIDT® PneumaticPress
and HydroPneumaticPress
can be controlled via a single-channel (e.g. in shielded
units) or via a two-channel pneumatic control block
(e.g. together with SCHMIDT® PressControl
600 and the the approved two-hand safety control).
The operational pressure is between 3 and 6 bars. Pressure
can be regulated to 1 bar, and thus the starting. With
the force output pre-selector (standard on hydro-pneumatic
presses) the pressure can be regulated to under 1 bar.
The approach force can be adjusted precisely via the
regulator. The force output preselector and the pneumatic
control blocks are available in two sizes (ISO 1 and
ISO 2) depending on the air consumption of the press.
Force output pre-selector and independent power stroke control
Pressure reducing valve with gauge
Connectors 1/4”(ISO 1)
Connectors 1/2”(ISO 2)
Single-channel pneumatic safety block
Service unit with main air valve (manual), filter pressure regulator, gauge and high-performance muffler
Pneumatic manifold block with 5/2-way solenoids valve
Will confirm that the end of the stroke has been reached.
Installed into hardened mounting block on top of fine
adjustment screw.
Triggered via the stroke limit block
of the press. Automatically accepts changes in strokes
adjustment.
Suitable for presses Nr. 20 - 29
Pneumatic Pressure Switch
Used on Direct Acting Presses to verify that pressure
has reached before press ram returns. Back lighted display,
LCD, On/Off set points.
Suitable for presses Nr. 20 - 29
Ram Drift Lock
Pilot operated check valve that prevents the ram from
drifting when the air cylinder is depressurized. This
device is useful in conjunction with heavy tooling.
NOTE: This device maintains pressure in the cylinder
chamber that it is connected.
Suitable for presses Nr. 20 - 76
Intermediate Stop
For two-stroke, three stroke or safety
stop sequential operation. Two stroke operation control
via one pneumatic valve.
Suitable for presses Nr. 20 - 29
Contact us for details
Note: If used with
a Stroke Completion Sensor,
reduce maximum height by 0.25"
