Press Control

Hydro-Pneumatic Presses

Enter your keywords:
 

Hydro-Pneumatic Press Accessories

 

High pressure sensors, pneumatic control blocks and force output preselector for pneumatic and hydro-pneumatic presses

Depending on the level of safety required, the SCHMIDT® PneumaticPress and HydroPneumaticPress can be controlled via a single-channel (e.g. in shielded units) or via a two-channel pneumatic control block (e.g. together with SCHMIDT® Press Control 600 and the the approved two-hand safety control). The operational pressure is between 3 and 6 bars. Pressure can be regulated to 1 bar, and thus the starting. With the force output pre-selector (standard on hydro-pneumatic presses) the pressure can be regulated to under 1 bar. The approach force can be adjusted precisely via the regulator. The force output preselector and the pneumatic control blocks are available in two sizes (ISO 1 and ISO 2) depending on the air consumption of the press.


Hydro-pneumatic High Pressure Sensor

Hydro-pneumatic High Pressure Sensor

  • This sensor verifies that pressure and/or press force has been reached before press ram returns. Can be used as an interface device to commence press timer, or added operator safety when using a two hand control device. Three decimal, Red LED, LCD, On/Off set points.
  • Suitable for press Nr. 61 - 76, 361 - 376

Force output pre-selector and independent power stroke control

Force output pre-selector and independent power stroke control

  • Pressure reducing valve with gauge
  • Connectors 1/4”(ISO 1)
  • Connectors 1/2”(ISO 2)

Single-channel pneumatic safety block

Single-channel pneumatic safety block

  • Service unit with main air valve (manual), filter pressure regulator, gauge and high-performance muffler
  • Pneumatic manifold block with 5/2-way solenoids valve
  • Connectors 1/4”(similar to ISO 1)
  • Connectors 1/2”(similar to ISO 2)

For integration with automated systems.

Two-channel pneumatic safety block

Two-channel pneumatic safety block

  • Service unit with main dump valve (3/2-way magnetic valve),filter, pressure regulator, P/E signal converter, gauge andhigh-performance muffler
  • Pneumatic manifold block with two 5/2-way solenoids valves•8-port manifold
  • Connectors 1/4”(similar to ISO 1)
  • Connectors 1/2”(similar to ISO 2)

Safety component for EC type-approved press systems bySCHMIDT Technology.

For integration with automated systems.


 

Find out more about these SCHMIDT® Hydro Pneumatic Presses:
C-Frame Press
H-Frame Press
Hydro Pneumatic Press with Force & Stroke Monitoring
Hydro Pneumatic Press Modular Units
Specifications
Dimensional Drawings
Air Consumption
Converter