Ergo Handle and Cycle Start

The Ergonomic Handle allows operation of any manual press with a more natural hand position, which greatly reduces fatigue.

The handle can easily be retrofitted to any manual press. All you need is a metric allen-wrench in order to secure two screws.

Remove the clamp piece & two screws, position the handle as desired, install & fasten the two screws with the clamp piece and continue operation. That simple!

While operating powered presses, the use of a sensor instead of push buttons eliminates the need of physical force by the operator. This sensor can be mounted in a variety of locations and orientations to ensure best possible operator comfort, as well as greater productivity.

When sensors are part of a two hand safety control, make sure the distance between the two permanently installed sensors does not allow initiation with only one hand/arm. This distance typically measures a minimum of 18 inches to ensure safe operation.